Maintenance-Object Repair Procedures
555-233-143
8-1340 Issue 1 May 2002
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The terminal equipment is not connected to the circuit pack. Some terminal
equipment, such as modems, may fail even when connected properly.
1. Remotely test the equipment.
2. If the test fails again, look for RING-GEN errors in the error log. If present,
see ‘‘RING-GEN’’ on page 8-1357.
3. Check all of the wiring between the station equipment and the switch.
Then, run the test again.
4. If the test still fails, the set may be defective. Check the set and replace it,
if necessary.
5. Some terminal equipment could fail even when it is connected properly. If
so, disable the test using the change station extension command (enter
n into the Test field). Note that this action also disables Test #35 on this
port.
PASS The station is connected properly. This test may also pass if no terminal
equipment is connected and the terminal is located very far from the switch.
Investigate user-reported troubles on this port by using other port tests,
examining station wiring, or examining the station.
Table 8-542. Test #48 Station Present Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
