SNI-BD (SNI Circuit Pack)
Issue 1 May 2002
8-1471555-233-143
2316 ABORT The reset of the SNI circuit pack was attempted via the connected DS1C circuit
pack. This ABORT code indicates that the fiber is not administered, but in this
particular case it also indicates a software problem.
1. Retry the command at 1-minute intervals up to 1 time.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
PASS The “reset” message was sent out successfully to the active SNC or to the
SNI’s neighbor. A PASS does not necessarily mean the SNI circuit pack was
successfully reset. The reset can be verified by checking that the red and
green LEDs turn on and then turn off. If an SNI circuit pack fails one of the
firmware tests run during its reset sequence, the red LED will stay on and the
circuit pack should be replaced.
0NO
BOARD
No board was detected by the test.
1. Check that board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNI should be reset
instead of reseating the circuit pack. The reset board command should
almost never be used on an SNI. It may be necessary to use the reset
board command if the SNI circuit pack gets into a mode where it cannot
communicate with software. If an SNI with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore the
reset board command can mask real problems.
3. Run the test again. If it fails, the ID chip on board may be bad. Replace
the board and retest.
Table 8-580. TEST #761 Switch Node Interface Reset Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
