Avaya S8700 - Page 2589

WAE-PORT (Wideband Access Endpoint Port)
Issue 1 May 2002
8-1867555-233-143
Error Log Entries and Test to Clear Values
Notes:
a. The wideband access endpoint has been busied out by a busyout
access-endpoint extension command. No calls can be made to this
extension.
b. The circuit pack has been removed or has been insane for more than
11 minutes. To clear the error, reinsert or replace the circuit pack.
c. The Conference Circuit test (#7) failed on this port. See Test #7 for repair
procedures.
d. The NPE Crosstalk test (#6) failed on this port. See Test #6 for repair
procedures.
e. The TN464C UDS1 Interface circuit pack has failed. See ‘‘UDS1-BD
(UDS1 Interface Circuit Pack)’’ on page 8-1707.
f. The Port Audit and Update test (#36) failed due to an internal system error.
Enter status access-endpoint extension and verify the status of the port.
If the wideband access endpoint port is out of service, enter release
access-endpoint extension to put it back into service. Retry the test
command.
Table 8-716. Wideband Access Endpoint Maintenance Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test’s description, and follow its recommended procedures.
0Any Any Anytest access-endpoint extension
sh r 1
18 (a) 0 busyout
access-endpoint
WARNING OFF release access-endpoint
extension
130 (b) None WARNING ON test access-endpoint extension
1281 (c) Conference Circuit
test (#7)
MINOR ON test access-endpoint extension
l r 4
1537 (d) NPE Crosstalk test
(#6)
MINOR ON test access-endpoint extension
l r 3
1793 (e) None test board UUCSS long
3840 (f) Any Port Audit and
Update test (#36)