Maintenance Commands
555-233-143
7-110 Issue 1 May 2002
Field Descriptions
Enable
Type y to enable a processor channel. Type n (default) to disable a
processor channel.
Appl.
Identifies the switch application used over this link. The application
gateway is used for conversion between ISDN and TCP/IP. Valid entries
are: audix, dcs, fp-mwi, gateway, gtwy-tcp, mis, msaamwl, msaclk,
msahlwc, msallwc, msamcs, qs-mwi, blank (default)
Gtwy To
Identifies which processor channel the given processor channel is serving
as a gateway to. Valid entries are a number between 1-(maximum number
of processor channels), or blank (default).
Mode
Identifies whether the IP session is passive (client) or active (server). This
field must be blank if the type of interface link is x.25 (r model) or procr-intf
(si model). This field cannot be blank if the type of interface link is ethernet
or ppp. Valid entries are client, server, or blank (default).
Interface Link
Identifies the physical link carrying this processor (virtual) channel. Links
numbered 1 through (4 times the number of PI circuit packs) for the si
model can be either x.25 or tcp/ip. The rest of the links (up to 25) must be
tcp/ip.
Destination
Node
Identifies the switch or adjunct at the far end of this link. Enter an adjunct
name, switch name, far-end IP address, node ID, or leave blank (default)
for services local to this switch.
Destination
Port
Identifies the port number of the destination. The number 0 means any port
can be used. Valid entries are 0 (default), 5000-64500.
Session Local
Field ported forward from R6.
Session Remote
Field ported forward from R6.
Mach ID
Field ported forward from R6.
To Next Page
Loading...
