display errors
Issue 1 May 2002
7-111555-233-143
display errors
display errors [high-resolution] [print | schedule]
The display errors command brings up an input form that allows you to select
which errors will be displayed on the hardware error report.
Errors can result from in-line firmware errors, periodic tests, failures detected
while executing a test command, software inconsistency, or a data audit
discrepancy. The error log is restricted in size. A new entry overwrites the oldest
unalarmed entry. The overwritten entry must be at least six minutes old, or the
new entry is dropped.
Help Messages
■ The following help message will be displayed when the first page of a
multiple page list of alarms/errors or after the
Prev Page key is pressed:
Press CANCEL to abort or NEXT PAGE for next page
■ The following help message will be displayed after the Next Page key is
pressed and there are more pages of alarms/errors to be displayed:
Press CANCEL to abort, NEXT PAGE for next page, PREV
PAGE for previous page
■ The following help message will be displayed after the Next Page key is
pressed and there are no more alarms/errors to be displayed:
Press CANCEL to abort, NEXT PAGE to complete, PREV PAGE
for previous page
Actions
■ The following command will display the next page of alarms/errors or echo
“Command successfully completed” and exit if there a no more pages of
alarms/errors to display:
Next Page
■ The following command will display the previous page of alarms/errors and
the “press CANCEL to abort or NEXT PAGE for next page” help message:
Prev Page
■ The following display command will be cancelled and echo “Command
aborted” and exit.
Cancel
To Next Page
Loading...
