list configuration
Issue 1 May 2002
7-163555-233-143
Output
Assigned Ports:
■ Board Number—The functional name of the circuit pack
■ Code—The TN or UN code and suffix of the circuit packs are displayed.
NOTE:
The letter P (programmable) is added to the suffix of every R10
downloadable board in the following forms:
■ list configuration
■ status firmware download
■ change firmware download
■ Vintage 00000000-065535 KKKKKK—The vintage number of the circuit
pack.
■ no board—The circuit pack is administered but not physically installed.
■ conflict—The circuit pack administered to the slot differs from the circuit
pack that is physically installed.
■ no link—The T1 link is down to a DS1 circuit pack.
Field Descriptions
Signaling
This field is displayed only when list configuration ds1 option is selected.
The contents of the field are the same as the signaling mode administered
for the ds1 circuit pack (via add/change ds1 command) or ”none” if the
circuit pack is not administered.
Name
This field is displayed only when “list configuration ds1” option is selected.
The contents of the field are the same as the name administered for the
ds1 circuit pack (by the add/change ds1 command) or “blank” if the circuit
pack is not administered.
CSU MOD
This field is displayed only when “list configuration ds1” option is selected.
The field contains the identification number of the Integrated CSU module
present on the ds1 circuit pack (TN767E or later / TN464F or later) or
“none”. If the circuit pack is a TN464E or TN767D, “unknown” will be
displayed. If the circuit pack is a TN464D or TN767C or earlier suffix DS1
board, then “n/a” will be displayed.
To Next Page
Loading...
