Maintenance Commands
555-233-143
7-164 Issue 1 May 2002
Assigned Ports
Each port on the circuit pack is represented by a position corresponding to its
circuit number in ascending order from left to right. The assigned ports are not
displayed for
list configuration ds1. Two rows are required for circuit packs with
more then 8 ports. The position displays one of the following values depending on
its administered status:
■ 01-16—The circuit number of an assigned port.
■ u—The port corresponding to this position exists but is unassigned.
■ t—The port is not currently assigned and is supported by the Terminal
Translation Initialization feature. Ports in this state can be activated by the
TTI association sequence.
■ mj—The port corresponding to this position is currently assigned as an
external device (mj) alarm port.
■ mn—The port corresponding to this position is currently assigned as an
external device (mn) alarm port.
Each port on a TN556 ISDN-BRI circuit pack can have two BRI endpoints. BRI
ports are displayed once when assigned only one endpoint and twice when fully
configured with two endpoints.
The following display shows a typical result when
list configuration all is
entered.
list configuration all Page 1
SYSTEM CONFIGURATION
Board Assigned Ports
Number Board Type Code Vintage u=unassigned t=tti p=psa
01A01 CALL CLASSIFIER TN744E 000002 01 02 03 04 05 06 07 08
01A02 IP SERVER INTFC TN2312AP HW32 FW042 01 02 03 04 05 06 07 08
01A05 IP MEDIA PROCESSOR TN2302AP HW03 FW034 01 02 03 04 05 06 07 08
01A06 CONTROL-LAN TN799C 000003 u u u u u u u u
u u u u u u u u
17
01A08 CO TRUNK TN747B 000026 u u u u u u u u
01A09 ANALOG LINE TN793B 000005 u u u u u u u u
u u u u u u u u
u u u u u u u u
01A10 DIGITAL LINE TN2224B 000003 01 u u u u u u u
u u u u u u u u
u u u u u u u u
press CANCEL to quit -- press NEXT PAGE to continue
To Next Page
Loading...
