Avaya S8700 - Page 554

Maintenance Commands
555-233-143
7-298 Issue 1 May 2002
BRI,
ASAI
64-126 L3-Established blank yes A demand SPID Facility test is in
progress on the port, and the link is
not currently associated with a BRI
endpoint. See SPID Facility test’s
procedures described in the
BRI-SET section of Chapter 8,
‘‘Maintenance-Object Repair
Procedures’’.
BRI 64-126 L3-Established ext# yes A demand SPID Facility test is in
progress on the port, and the link is
associated with an endpoint on the
port. See SPID Facility test’s
procedures described in the
BRI-SET section of Chapter 8,
‘‘Maintenance-Object Repair
Procedures’’.
BRI 0-126 L3-Established blank blank An invalid SPID is assigned to link.
1. Change the SPID value in the
BRI endpoint to match the SPID
administered to the BRI
endpoint on the port. Repeat
status bri-port to determine
whether the Layer 2 state of the
signaling link is
L3-Established. If it is
not, follow normal escalation
procedures.
Table 7-45. Interpreting BRI-Port Status Reports — Continued
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
Continued on next page