Avaya S8700 - Page 590

Maintenance Commands
555-233-143
7-334 Issue 1 May 2002
AUDIO
(cont’d.)
Other possible AUDIO mode values include neutral (neutralized I-channel)
and
Au-off, Frm (no audio signal) which never match conference mode
and are not supported by MCU.
56/64 The 56/64 field is derestrict when operating at per-channel rates of
either 64, 128, 192, 256, 320, 384, 512, 768, 1472, 1536, or 1920 kbps. It is
restrict when operating at rates of either 56, 112, 168, 224, 280, 336, 448,
or 672 kbps.
Note that if the conference is configured for N x 56-kbps operation, the
endpoint may signal either via capabilities or modes that is operating at the
proper rate. In such a case, even when we receive
derestrict command
which does not match the conference communication mode of
restrict, if
the capability indicates
restrict (MISC capability has restrict
displayed on Page 4) the
STAT 56/64 is set to y to indicate 56/64
compatibility between the conference and the endpoint.
VIDEO The Video mode:
H.261 (recommended), H.CTX (proprietary), H.CTX+
(proprietary), or
SG4 (proprietary) indicate that video is on in the direction
indicated;
video-off when the video is off.
MLP Multi Layer Protocol data mode. When
Data Mode is administered as
any-mlp or ww-pcs, the MLP mode should be var-MLP. Other values will
affect video status.
The MLP mode should be MLP-off when Data Mode is administered as
none. Again, other values in this mode will affect video status.
H_MLP The High Speed MLP mode. The HMLP mode should be
H-MLP-off. Other
values in this mode will affect video status.
LSD Low Speed Data mode. The LSD mode should be
LSD-off. Other values in
this mode will affect video status.
HSD High Speed Data mode. The HSD mode should be
HSD-off. Other values
in this mode will affect video status.
CRYPT Encryption mode. The CRYPT mode should be encrypt-off. Other
values in this mode will affect video status.
S/M Single-/multi-channel interoperability mode.
6B-H0-comp indicates that the
sender is interoperating multiple channels and a single channel (for example,
6B and H0). Not-comp-6B-H0 indicates that the sender is not
interoperating between 6B and H0. Normally this value is
Not-comp-6B-H0. Other values in this mode will affect video status.