Avaya S8700 - Page 591

status conference
Issue 1 May 2002
7-335555-233-143
Endpoint Miscellaneous (EPT MISC) Information. EPT MISC contains
miscellaneous states and counters for an endpoint. The flags can be a value of
y
or
n. The counters start with initial value of 0x00, they increment to 0xff, and then
wrap around to 0x01.
AIM and VIS are BAS commands which can be sent as
input (I) to MCU from an endpoint or as output (O) from MCU to an endpoint.
AIM Audio Indicate Muted. Value of y on input (I) indicates that this endpoint has
muted its audio. MCU will not VAS to an endpoint displaying mute indicate.
Value of n on input indicates that this endpoint has not muted (only if endpoint
audio mode is turned on). Value of
y on output (O) indicates that every other
endpoint in the conference has muted its audio (have sent AIM to MCU). MCU
in turn tells this endpoint (by sending it AIM) that there is no audio output from
MCU. A value of n on output indicates that there is an audio path open across
the bridge.
VIS Video Indicate Suppressed. Value of
y on input (I) indicates that this endpoint
has suppressed its video (indicated video is muted). Value of
y on output (O)
indicates that the MCU is not sending video to this endpoint because there is
no video broadcaster (broadcaster has not joined or broadcaster’s video is not
valid).
MIS Multipoint Indicate Secondary-status. This command is only sent as output (O)
to an endpoint. A value of n indicates that the endpoint is viewed as capable of
being a valid source (although not necessarily at this moment). A value of n is
the correct state to be in for video. A value of
y indicates that MIS was sent to
an endpoint and that this endpoint is viewed as a secondary endpoint. The
endpoint is included in the audio portion of the conference but not the video
portion. Video will not be sent.
MCV Multipoint Command Visualize. This command is only sent as input (I) from an
endpoint. A value of
y indicates that an endpoint has requested to become a
broadcaster. This is used during Still Frame Graphics and to force
“presentation” mode.
TALK A value of
y indicates that the VC board is detecting voice energy from the
endpoint. The TALK counter indicates the number of times a start/stop was
detected.
VRCV Value of
y indicates if the endpoint is receiving video (MMCH is sending video
to the endpoint). The VRCV counter indicates the number of times video was
sent/not sent to this endpoint.
BCTK Applies to single screen and quad-screen presentation mode conferences. A
value of
y indicates that the endpoint is the video broadcast source. The BCTK
counter indicates the number of times this endpoint was the video broadcast
source.
RTTK Applies only to single screen conferences. A value of
y indicates that the
endpoint is the return video source. The RTTK counter indicates the number of
times this endpoint was the return video source.
BCLS Applies to single screen and quad-screen presentation mode conferences. A
value of
y indicates that the endpoint is watching the video of the broadcast
source.
RTLS Applies only to single screen conferences. A value of y indicates that the
endpoint is watching the video of the return source.