EasyManua.ls Logo

Avaya S8700 - Page 821

Avaya S8700
2618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ANL-LINE, ANL-NE-L (8-Port Analog Line)
Issue 1 May 2002
8-99555-233-143
1005 ABORT The test was aborted due to a configuration problem. This code occurs under
either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
TN742 vintages 13, 14, and 15
TN769 vintages 3, 4, and 5
1008 ABORT Could not allocate a ringing circuit for one of the following reasons: (1) every
ringing circuit is active, or (2) the ringing generator is defective, or (3) it is
incorrectly wired.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error Log. If
an ABORT 1008 occurs for Test #48 on other circuit packs as well, then the
ringing generator may be defective or incorrectly wired. If it does not occur
on other ports, then that circuit pack is currently using all four ringing
phases.
1018 ABORT The test was disabled via administration. The default for the
Test? field is y;
thus, you may want to determine why this field has been set to n on this
station (this may be due to the ringing application Test #48, which can be
customer or terminal disturbing).
1. To enable the test for a particular station, enter change station extension
and set the
Test? field to y.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available. Either a system
allocation to get information about the port or to put the port into a service state
failed or the attempt to put the port in connection with a tone source failed (this
could be a Tone-Clock problem). The Tone-Clock and Tone Detectors could
be having a communication problem. (For example, the companding modes
could be out of synchronization.)
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
Table 8-38. Test #48 Station Present Test Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page

Table of Contents

Other manuals for Avaya S8700

Related product manuals