ANN-PT (Announcement Port)
Issue 1 May 2002
8-139555-233-143
FAIL Test failed. Announcements played back on this port may sound corrupted.
1. Reset the circuit pack using the reset board UUCSS command and then
run this test again. If the test continues to fail, replace the circuit pack.
2. If there are recurring alarms on this port caused by this test failing, replace
the circuit pack even if step 1 works.
!
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
Refer to ‘‘Essential Service Information’’ on page 8-120 of the AN-LN-PT
MO.
PASS This test verifies that the Angel processor can properly set up this port for
playbacks. User-reported troubles on this circuit pack should be investigated
using other port and circuit pack tests. (Refer to ‘‘AN-LN-PT (Analog Line
Port)’’ for a description of the circuit pack tests.)
Table 8-53. Test #205 CAMA (Channel Administration Memory Array)
Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
