Maintenance-Object Repair Procedures
555-233-143
8-148 Issue 1 May 2002
The switch sent a message to an endpoint that did not respond in the
allotted time. This may be due to failure of the point-to-point signaling link
or because of a problem in the ASAI adjunct. To repair:
■ Execute the test station extension command and perform the
associated repair procedures for those tests.
b. An endpoint is not responding to the service state query message sent to
the adjunct or to the endpoint. This error causes an alarm to be raised.
The alarm is retired when the switch receives a response to the service
state query to the endpoint or to the adjunct.
When this error occurs for an ASAI adjunct, the Aux Data field indicates the
state of the ASAI link and whether an invalid response or no response was
received to the query from the switch, as shown in the following table:
See ‘‘status bri-port’’ on page 7-294 for an explanation of the ASAI link
states.
Aux Data Timer Type
2 First T303 (SETUP timer)
3 Second T303 (SETUP timer)
4 T305 (DISConnect timer)
5 First T308 (RELease timer)
6 Second T308 (RELease timer)
10 T316 (RESTart timer)
12 T309 (Layer-2 Failure timer)
16 TM100 (Management Information message Timer 1)
17 TM200 (Management Information message Timer 2)
102 TASAI (ASAI Routing Timer)
Aux Data ASAI Link State Error
102 13-restarting No response to RESTART message
104 13-restarting Invalid response to RESTART message
152 13-restarted No response to layer-3 query
154 13-restarted Invalid response to layer-3 query
202 13-established No response to layer-3 query
204 13-established Invalid response to layer-3 query
To Next Page
Loading...
