ATM-EI (Expansion Interface Circuit Pack)
Issue 1 May 2002
8-189555-233-143
Basic ATM PNC Administration
NOTE:
This section contains basic administration information only. Refer to ATM
Installation, Upgrades, and Administration for Avaya MultiVantage Solutions
for more detailed information.
ATM PNC connections involve administering
■ 1 ATM-EI board in each EPN (standard, duplex, or high reliability)
■ 2 ATM-EI boards in each EPN (critical reliability)
Adding ATM PNC Connections
Standard, Duplex or High Reliability
1. If the ATM-EI circuit pack is absent or if the circuit pack is present but in an
EPN, use the change circuit-pack command to add circuit pack
translations.
2. Enter add atm pnc n (connection number), and administer the circuit
pack’s location and its ATM address.
Critical Reliability
1. Enter change system-parameters duplication, and change the Enable
Operation of PNC Duplication field to n.
2. If the ATM-EI circuit pack is absent or is present but in an EPN that does
not yet have PNC connectivity to it, use the change circuit-pack
command to add circuit pack translation for the missing circuit pack.
3. Enter add atm pnc n (connection number), and administer the circuit pack
location and ATM address.
4. Enter change system-parameters duplication, and change the Enable
Operation of PNC Duplication field to y.
Removing ATM PNC Connections
Standard, Duplex or High Reliability
NOTE:
These systems are not equipped with PNC duplication.
1. Enter busyout atm pnc n (connection number).
2. Enter remove atm pnc n (connection number).
To Next Page
Loading...
