Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
135
of 820
4
128.2 Temperature acquisition system
This parameter is used to switch the motor temperature detection and monitoring on and
off, and also the determine the connection to the device.
128.3 Motor temperature
Display of the measured motor temperature in °C
Is important if the motor temperature monitoring is switched on (value Z128.2– bits 0 to
7 ≠ 0 and 1 and 3), only.
128.4 Warning threshold 1
Motor temperature threshold 1. If the motor temperature exceeds this value, Warning 710
is generated.
128.5 Warning threshold 2
Motor temperature threshold 2. If the motor temperature exceeds this value, Warning 711
is generated.
128.7 Motor temperature hysteresis
Hysteresis for canceling Warnings 710 and 711 initiated by Z128.4– Warning Threshold
1 and Z128.5– Warning Threshold 2.
Bit Meaning
7 ... 0 Selection of the connection for the motor temperature encoder:
0: No encoder, or motor temperature monitoring off
1: Connection to encoder input or X101
2 … 255 reserved
15 ... 8 Reserved
To Next Page
Loading...
Need help?
General