INSTALLATION AND STARTUP
1MANUL220 Belanger, Inc.® * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 4-29
Chapter 4 Frame and Carriage Assembly
Passenger Side Boom Install
Optional HydroBlade®/ Wheel Cleaner
HydroBlade® Center Feed Manifolds
1) Remove the clamps that are circled below to remove the manifold assembly (as shown below).
2) Change the orientation of the components pointed out below.
3) Change the orientation of the components pointed out below.
Note: If you have purchased the optional low pressure feed kit, you may need to disconnect any
airlines that are connected to it. It is a good practice to label the airlines for ease of
reinstallation.
4) Secure the manifold assembly into place and re-connect the hoses to the previous fitting locations. See image
below.
To Next Page
Loading...
