BONFIGLIOLI Agile

Parameter descriptions
Configuration
Asynchronous motor
Synchronous
motor
V/f character-
istic
Field-orientated control
Function
Chapter
110
410
610
Modulation controller
7.9.5.6
x
x
Starting behavior
7.3.2
x
x
x
Starting current impression
7.3.2
x x x
Flux-formation
7.3.2
x x x
Stopping behavior
7.3.3
x x x
Direct current brake
7.3.6
x
Auto start
7.3.4
x x x
Flying Start
7.3.5
x x x
Energy saving
8
x x x
Energy saving function (Flux reduction)
8.1
x x
Reference point positioning
7.3.7
x x x
PLC function
7.6.6.16
x x x
Frequency reference channel
7.5.1
x x x
Reference percentage channel
7.5.1.3
x x x
Fixed frequencies
7.5.1.3
x x x
Fixed percentages
7.5.2
x x x
Blocking frequencies
7.5.1.5
x
x
x
Input PWM/repetition frequency/pulse
train
7.5.4
x x x
Brake chopper
7.10.4
x
x
x
Motor circuit breaker
7.10.6
x
x
x
V-belt monitoring
7.10.7
x
x
x
Motor chopper
7.10.5
x x
Real-time tuning
7.9.6
x x
7.1.3 Set password
27 Set password
As a protection against unauthorized access, the parameter
Set password 27 can be set such that
anyone who wants to change parameters must enter this password before. A change of parameter is
only possible if the password is entered correctly. If the
Set password 27 parameter is set to zero, no
password is required for access to the parameters. The previous password is deleted.
Parameters
Setting
No.
Identification
Min.
Max.
Fact. sett.
27
Set password
0
999
0
If a password is set the password entry is necessary for
− modification of parameter values
− start of Setup
− upload of parameter values from memory card to frequency inverter
The correct entered password unlocks all functions for 10 minutes. After 10 minutes the password
protection is switched on again automatically.
The modification of a password is possible in control level 3 (parameter Control level 28).
112
Operating Instructions
Agile 06/2013 Inverter Data