Canon iPF6400S - Menu Settings

Menu Settings
Menu Settings
Menu items are as follows.
The printer menu is classified into regular menu items available when no print job is in progress and menu during
printing items only available while printing is in progress. see "Printer Menu Operations." ➔ P.578
Regular menu Menu during printing
Paper Menu Not displayed
Ink Menu The same Ink Menu as normal is displayed.
Job Menu The same Job Menu as normal is displayed.
Set./Adj. Menu A limited Set./Adj. Menu containing the following items is displayed.
• Adj. Fine Feed (*1)
• Printer Info
*1: Only displayed in the menu during printing. Not displayed in the regular menu.
For instructions on selecting menu items, see "Menu Operations." ➔ P.579
For details on the displayed menu hierarchy, see "Menu Structure." ➔ P.582
Menus may change according to the optional products in use.
Paper Menu
The Paper Menu is not displayed during printing.
Setting Item Description, Instructions
Load Paper Select either manually loaded sheets or rolls and load the paper.
Eject Paper Choose this item before removing loaded paper.
Chg. Paper Type (*1) Change the type of paper loaded. (See "Changing the Type of Pa-
per.") ➔ P.476
Chg. Paper Size Change the size of paper loaded. (See "Specifying the Paper
Length.") ➔ P.477 (See "Paper Sizes.") ➔ P.460
ManageRemainRoll Choose On to print a barcode at the end of a roll before you remove
it. The printed barcode can be used in managing the amount of roll
paper left. Choose Off if you prefer not to print the barcode.
(See "Keeping Track of the Amount of Roll Paper Left.") ➔ P.481
Paper Details (The type of paper
is displayed here.)
(*1)
Head Height Adjust the Printhead height. (See "Troubleshooting Paper Abrasion
and Blurry Images.") ➔ P.712
Skew Check Lv. If you print on Japanese paper (washi) or other handmade paper that
has an irregular width, choose Loose for a higher skew detection
threshold, or choose Off to disable skew detection. However, if paper
is loaded askew when detection is Off, note that paper jams or Platen
soiling may occur.
Cutting Mode Specify whether or not to cut with the standard round-bladed cutter.
If you choose Automatic, the roll will be cut automatically using the
Cutter Unit, depending on the printer driver settings.
Select Eject to prevent printed documents from falling immediately
after printing such as when you wait for the ink to dry, etc. Manual
prints lines at the cut position instead of cutting after printing. If you
select Manual, the setting screen for detection of the paper leading
edge is displayed.
(See "Specifying the Cutting Method for Rolls.") ➔ P.483
Cut Speed Choose the cutting speed. The preset selection represents the opti-
mal cutting speed for the type of paper. We recommend keeping the
preset cutting speed.
If you use adhesive paper, choosing Slow helps prevent adhesive
from sticking to the cutter and keeps the cutter sharp.
Trim Edge First Selects whether or not to automatically cut the leading edge of the roll
paper when roll paper is loaded.
(See "Cutting the Leading Edge of Roll Paper Automatical-
ly.") ➔ P.489
iPF6400S
Menu Settings
User's Guide
Control Panel Printer Menu
587