Cleaning the Printer
Cleaning the Printer
Cleaning the Printer Exterior ..................................................................................................................................... 839
Cleaning Inside the Top Cover ................................................................................................................................. 839
Cleaning the Paper Retainer ...................................................................................................................................... 842
Cleaning the Printhead ................................................................................................................................................ 825
Cleaning the Spectrophotometer Unit (option) Parts .................................................................................... 843
Cleaning the Printer Exterior
Cleaning the Printer Exterior
Clean the printer regularly to maintain better printing quality and help prevent problems.
About once a month, clean the printer exterior.
1
Turn the printer off. (See "Turning the Printer On and Off.") ➔ P.21
2
Unplug the power cord from the outlet.
Caution
• Always turn off the printer and unplug the power cord before cleaning or maintenance. Accidentally leaving the
printer on poses a risk of injury if you touch moving parts inside the printer.
3
Using a damp cloth that you have wrung out com-
pletely, wipe the exterior surfaces of the printer. Dry
the surfaces with a dry cloth.
Warning
• Never use flammable solvents such as alcohol, benzene, or thinner. If these substances come into contact with
electrical components inside the printer, there is a risk of fire or electrical shock.
Important
• If the Ejection Guide is dirty, it may soil the edge of the paper when the paper is cut. We recommend cleaning
the Ejection Guide even if it does not appear dirty, because it may actually be covered with paper dust.
4
Plug the power cord into the outlet.
Cleaning Inside the Top Cover
Cleaning Inside the Top Cover
Clean inside the Top Cover about once a month to maintain better printing quality and help prevent problems.
Also clean inside the Top Cover in the following situations to ensure optimal operation.
•
If the printed surface or the underside of paper is dirty after printing
•
After you have used up a roll
•
After borderless printing
•
After printing on small paper
•
After printing on paper that generates a lot of cutting debris
•
If you have replaced the roll
•
After printing on paper that generates a lot of paper dust
•
If the message "Blue platen switch is dirty." is displayed
iPF6400S
Cleaning the Printer Exterior
User's Guide
Maintenance and Consumables Cleaning the Printer
839
To Next Page
Loading...
