"Replace with a 16-inch wide or wider roll paper."
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet or other
printer status information.)
Replace the roll with a roll 16 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") ➔ P.478
(See "Removing Rolls From the Roll Holder.") ➔ P.480
2.
Replace the roll with a roll 16 inches wide or larger.
(See "Loading Rolls on the Roll Holder.") ➔ P.471
(See "Loading Rolls in the Printer.") ➔ P.473
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Cannot calibrate.
Cannot calibrate.
Cause Corrective Action
The paper for printing a test pattern is soiled.
Otherwise, you have loaded colored paper.
Press the OK button to clear the error.
Load unused paper compatible with color calibration.
See the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.") ➔ P.464
The test pattern was printed too faintly. Press the OK button to clear the error.
Take steps to remedy faint printing.
(See "Printing is faint.") ➔ P.881
Direct sunlight or strong lighting may be shining
on the printer and causing the sensor to mal-
function.
Press the OK button to clear the error.
Take steps to ensure the printer is not used when exposed to direct sunlight or strong
lighting.
Excessive temperature or humidity.
Excessive temperature or humidity.
Cause Corrective Action
The temperature or humidity
where the printer is installed is
out of the acceptable range for
operation.
Press ▲ or ▼ to select Stop, and then press the OK button to stop printing.
Use the printer under suitable environmental conditions. Also note that various environmental conditions
are recommended for various types of paper. For details on the recommended environmental conditions,
see the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.") ➔ P.464
Please execute common calibration.
Please execute common calibration.
Cause Corrective Action
There is not even one Common calibration execution result.
Note that this is displayed when all of the following are satisfied.
•
If Set Exec. Guide is On in the Control Panel menu.
•
If the printer is loaded with a type of paper on which color calibration cannot be executed.
Execute Common calibration.
(See "Color Calibration Using the Printer
Sensor.") ➔ P.736
Set Set Exec. Guide to Off on the Control
Panel menu.
(See "Menu Structure.") ➔ P.582
Please commn calibrt using above paper.
Please commn calibrt using above paper.
Cause Corrective Action
It is now recommended that you execute Common calibration.
Note that this is displayed when Set Exec. Guide in the Control Panel menu is set to On and any of the
following is true.
•
If the printer is loaded with a type of paper on which color calibration cannot be executed and the prede-
fined conditions since executing the Common calibration the last time have been reached.
•
Although a media type that color calibration can be executed on is loaded in the printer, there is no re-
cord or performing color calibration on that media, and the designated criteria from executing Common
calibration the last time have been reached.
Execute Common calibra-
tion.
(See "Color Calibration Us-
ing the Printer Sen-
sor.") ➔ P.736
Set Set Exec. Guide to Off
on the Control Panel menu.
(See "Menu Struc-
ture.") ➔ P.582
iPF6400S
Cannot calibrate.
User's Guide
Error Message Messages regarding printing or adjustment
913
To Next Page
Loading...
