Depression on the leading edge is left
Depression on the leading edge is left
Cause Corrective Action
Keeping a roll in the printer for a long time with-
out printing on it may leave a depression on the
leading edge.
When printing quality is most important, we recommend setting TrimEdge Reload to On
or Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.") ➔ P.582
Margins are wide
Margins are wide
Cause Corrective Action
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
This operation is normal.
When Cutting Mode in the Control Panel menu was
set to Manual, you selected Do not perform in re-
sponse to the "Perform the detection of paper lead-
ing edge?" message.
Set Cutting Mode to Manual again, and select Perform(recommend) when the
"Perform the detection of paper leading edge?" message is displayed.
Note that when you select Perform(recommend), if the paper is strongly curled,
the Printhead may rub against the leading edge of the paper when the printing
starts.
(See "Specifying the Cutting Method for Rolls.") ➔ P.483
Depression on the leading edge is left
iPF6400S
User's Guide
Troubleshooting Problems Regarding Paper
878
To Next Page
Loading...
