16
Cedex HiRes Analyzer Operator’s Guide
FCC Notification
Changes or modifications to this unit not expressly approved by the party responsible for compliance may
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
frequency energy and, if not installed and used in accordance with the Instruction Manual, may cause harmful
interference to radio communications. Operating this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at their own expense.
Electrical Safety
The Cedex HiRes Analyzer is designed in accordance with Protection Class I (IEC). The chassis/
housing of the instrument is grounded to protection earth (PE) by means of a cord. For protection
against electrical shock hazards, the instrument must be directly connected to an approved
power source such as a three-wire grounded receptacle for the 110 V or 230 V line. Do not use
an ungrounded receptacle; have a qualified electrician replace the ungrounded receptacle with
a properly (PE) grounded receptacle in accordance with the local electrical code. Do not use an
extension. Any break in the electrical ground path, whether inside or outside the instrument, could be
hazardous.
Under no circumstances should the user attempt to modify or deliberately defeat the safety features of
this instrument. If the power cord becomes cracked, frayed, broken, or otherwise damaged, replace it
immediately with the equivalent part from Roche Diagnostics.
Malfunction Due to Interfering Electromagnetic Fields
Malfunction of system and incorrect results due to interfering electromagnetic fields
This system is designed and tested to CISPR 11 Class A standard. In a domestic environment it may
cause radio interference, in which case, you may need to take measures to mitigate the interference.
c The electromagnetic environment should be evaluated prior to operation of the device.
c
Do not operate this system in close proximity to sources of strong electromagnetic fields (for
example unshielded intentional RF sources), as they may interfere with proper operations.
Warnings and Precautions
To Next Page
Loading...