Cisco ASR 1002 Hardware Installation Guide

DETAILED STEPS
Step 1
Inspect the box for any shipping damage. (if there is damage contact your service representative).
Step 2
Unpack the Cisco ASR 1000 Series Router.
Step 3
Perform a visual inspection of the chassis.
Step 4
After you have unpacked the system verify that you have received all of the required components. Using the packing
list as a guide, take the following steps to check the contents of the Cisco ASR 1000 Series Router shipping container:
Step 5
Check the contents of the boxes containing accessory items. Verify that you have received all equipment listed in your
order.
Step 6
Check that all Cisco ASR 1000 Series route processors, Cisco ASR 1000 Series embedded services processors, Cisco
ASR 1000 Series SPA interface processors (SIPs), and power supplies you ordered are installed in the chassis. Ensure
that the configuration matches the packing list.
Checking the Shipping Container Contents
Use the components list shown in the following table to check the contents of the Cisco ASR 1000 Series
Router shipping container. Do not discard the shipping container. You need the container if you move or ship
the Cisco ASR 1000 Series Router in the future.
Table 45: Cisco ASR 1000 Series Router Shipping Container Contents
DescriptionComponent
Cisco ASR 1000 Series Router configured with dual
AC or dual DC power supplies and a shared port
adapter blank panel if a shared port adapter has not
been ordered.
Chassis
Cisco ASR 1000 Series Router Hardware Installation Guide
135
Preparing Your Site for Installation
Checking the Shipping Container Contents

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g