Cisco ASR 1002 Hardware Installation Guide

What to Do Next
You have removed the eUSB device from the Cisco ASR 1001 Router.
Remove and Replace the eUSB Device on the Cisco ASR 1001 Router
To replace the eUSB component into the Cisco ASR 1001 Router, follow these steps:
SUMMARY STEPS
1.
With the chassis cover removed, align the replacement eUSB device over the connector and standoff. The
device fits over the threaded post that sticks up off the board and accepts a screw to hold the eUSB firmly
to the Cisco ASR 1001 chassis base.
2.
Gently insert the new eUSB device by pressing it into the connector while keeping the eUSB device aligned
with the standoff. Secure the eUSB device with the small Phillips screw, as displayed in the following
figure.
3.
Replace the chassis cover and power supplies. To replace the Cisco ASR 1001 Router top cover:
4.
Install the power supplies into the chassis. See: xref sections.
5.
Restore the backup copy of the startup-config and the boot image to the eUSB device:
6.
Verify that the Cisco ASR 1001 Router is operating properly. Check whether the internal hard drive LED
(labeled as DISK HD) is flashing green. To check if the LED is flashing green, from the ROMMON or
IOS prompt, run the following command:
7.
To restore data after the internal hard drive replacement, run the following command:
Cisco ASR 1000 Series Router Hardware Installation Guide
525
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Remove and Replace the eUSB Device on the Cisco ASR 1001 Router

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g