Cisco ASR 1002 Hardware Installation Guide

CHAPTER 13
Cisco ASR 1000 Series Routers Power Up and
Initial Configuration
This chapter guides you through a basic router configuration, which is sufficient for you to access your
network. Complex configuration procedures are beyond the scope of this publication and can be found in
the modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco hardware.
To configure the Cisco ASR 1000 Series Router from a console, you need to connect a terminal to the router
console port.
This chapter contains the following sections:
•
Checking Conditions Prior to System Startup, page 461
•
Verifying Power Supply Operation, page 462
•
Powering Up the Cisco ASR 1000 Series Routers, page 463
•
Configuring the Cisco ASR 1000 Series Routers at Startup, page 467
•
Powering Off the Cisco ASR 1000 Series Router Safely, page 470
Checking Conditions Prior to System Startup
Ensure that the following conditions are addressed before starting up the router:
•
The shared port adapter is inserted in its slot.
•
The network interface cable is connected.
•
The optional Fast Ethernet Management port cable is installed.
•
The chassis is securely mounted and grounded.
•
The power and interface cables are connected
.
•
Your PC with terminal emulation program (hyperTerminal or equivalent) is connected to the console
port and powered up.
Cisco ASR 1000 Series Router Hardware Installation Guide
461

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g