Cisco ASR 1002 Hardware Installation Guide

Table 62: Cisco ASR 1002-F Router SPA LEDs
MeaningStateColorLED Label
SONET alarm controller
is shut down.
OffOffC/A
Port is enabled by
software and there is a
valid SONET alarm
signal without any alarms.
OnGreen
Port is enabled by
software and there is at
least one alarm.
OnAmber
Interface is shut down.OffOffA/L
Port is enabled by
software and loopback is
off.
OnGreen
Port is enabled by
software and loopback is
on.
OnAmber
SPA power is off.OffOffSTATUS
SPA is ready and
operational.
OnGreen
SPA power is on and
good and the SPA is
being configured.
OnAmber
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router
Description
The Cisco ASR 1002-SIP10-F in the Cisco ASR 1002-F Router is integrated into the chassis and you cannot
insert or remove it. The Cisco integrated ASR 1002-SIP10-F provides the physical and electrical termination
for one half-height SPA.
The Cisco integrated ASR 1002-SIP10-F interface supports all Cisco SPA interface processor functions and
services. However, the Cisco integrated ASR 1002-SIP10-F differs in the following areas:
•
Functions as the base board for the Cisco integrated RP
•
Is not a field-replaceable unit (FRU) and does not support online insertion and removal (OIR)
Cisco ASR 1000 Series Router Hardware Installation Guide
282
Cisco ASR 1002-F Router Overview and Installation
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router Description

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g