Cisco ASR 1002 Hardware Installation Guide

DC power supply terminal
block plug being inserted
into terminal block header.
2Lead wires secured with a
tie wrap
1
Step 11
Make certain the terminal block plug is fully seated in the terminal block header on the DC power supply panel. You
will hear a snap or click when installed properly.
Step 12
Remove the tape (if any) from the circuit-breaker switch handle and move the circuit-breaker switch handle to the on
position.
Step 13
On the rear of the router, place the power supply Standby switch in the on position (O) to turn on the router.
The power supply LEDs light when power is supplied to the router.
What to Do Next
This completes the procedure for connecting the DC power supply in the Cisco ASR 1001 Router.
Repacking the Router
If your system is damaged, you must repack it for return shipment.
Before you return the router or move the router to a different location, follow these instructions to repack the
system, using the original packaging material:
SUMMARY STEPS
1.
Place the bottom packing material section inside the bottom of the shipping container.
2.
Use at least two people to place the Cisco ASR 1000 Series Router inside the container. Be sure that the
chassis is positioned correctly before you lower it inside the container.
3.
Place the top packing material over the top of the Cisco ASR 1000 Series Router.
4.
Place both accessory boxes inside the cutouts in the top section of the packing material.
5.
Fold the outside carton down over the top of the accessory boxes and seal with packing tape.
6.
Wrap two packaging straps tightly around the top and bottom of the package to hold the outside carton
and the bottom pallet.
Cisco ASR 1000 Series Router Hardware Installation Guide
612
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Repacking the Router

Cisco ASR 1002 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.3
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
DHCP client	-
Supported network protocols	BGP, GRE, OSPF, DVMRP, EIGRP, IS-IS, IGMPv3, PIM-SM, PIM-SSM
Ethernet LAN (RJ-45) ports	4
Security algorithms	SSH
VPN tunnels quantity	8000
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	4096 MB
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	560 W
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Product color	Gray
Rack capacity	2U

Weight and Dimensions

Depth	461 mm
Width	437.4 mm
Height	89 mm
Weight	- g