Cisco ASR 1002

•
Two embedded services processors (Cisco ASR1000-ESP40, Cisco ASR1000-ESP100, or Cisco
ASR1000-ESP200)
•
Cisco ASR1000-RP2 route processor
•
Quad power supplies (redundant pairs) by default; option of either AC or DC power supplies and two
power supply zones. There are two power supplies for power zone 0 and two power supplies for power
zone 1 (do not mix AC and DC power supplies).
You must have one power supply running at all times from each power supply zone and two power supplies
from each power supply zone to support redundancy. For detailed power supply information about the
Cisco ASR 1013 Router, see the Connecting Power to the Cisco ASR 1013 Router, on page 393.
Note
Cisco ASR 1000 Series Router Hardware Installation Guide
366
Cisco ASR 1013 Router Overview and Installation
Cisco ASR 1013 Router Description