Cisco ASR 1002

CHAPTER 4
Cisco ASR 1000 Series Router SPA Interface
Processors (SIPs)
This chapter describes the Cisco ASR 1000 Series Router SPA Interface Processors supported on the Cisco
ASR 1000 Series Routers.
This chapter contains the following sections:
For detailed documentation on Cisco ASR 1000 SIPs and SPAs, see:
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
Throughout this document, the term slot refers to the Cisco ASR 1000 Series Router chassis slot. The
Cisco ASR 1000 Series Route Processor, Cisco ASR 1000 Series Embedded Services Processor, and
Cisco ASR 1000 Series SPA Interface Processor (SIP), and power supplies plug into these slots. Shared
port adapters plug into SIP bays.
Note
•
Cisco ASR 1000 Series SPA Interface Processor, page 101
•
SPA Interface Processor Slot Numbering, page 104
Cisco ASR 1000 Series SPA Interface Processor
This section describes the Cisco SPA interface processors for the Cisco ASR 1006, Cisco ASR 1004, Cisco
ASR 1002, and Cisco ASR 1013 routers. The Cisco ASR 1000 Series Routers support the following Cisco
ASR 1000-SIPs:
• Cisco ASR 1000-SIP10—This SIP supports:
◦
4 half height (¼ Rate or full rate or combination) SPAs with up to 16 ports per SPA
◦
2 full height (¼ Rate or full rate or combination) SPAs with up to 32 ports per SPA
◦
2 half height and 1 full height comb in at on that does not exceed 64 ports
◦
Up to 10 Gbps of oversubscription
Cisco ASR 1000 Series Router Hardware Installation Guide
101