Cisco ASR 1002

CHAPTER 14
Removing and Replacing FRUs from the Cisco
ASR 1000 Series Routers
This chapter describes procedures for removing and replacing field-replaceable units (FRUs) from Cisco
ASR 1000 Series Routers:
•
Removing and Replacing Cisco ASR 1000 Series Route Processors, page 474
•
Removing and Replacing Cisco ASR 1000 Series Route Processor Internal Hard Drive, page 476
•
Removing and Replacing the Hard Drive on the Cisco ASR 1002-X Router, page 487
•
Removing and Replacing the Hard Drive on the Cisco ASR 1001 Router, page 491
•
Removing and Replacing the Cisco ASR 1000 Series DIMM Memory Modules, page 494
•
Removing and Replacing Cisco ASR 1000 Router eUSB Devices, page 519
•
Removing and Replacing Cisco ASR 1000 Series Router 1 GB USB Flash Token Memory Stick, page
527
•
Minimum Requirements of eUSB Devices Supported on Cisco ASR 1000 Series Routers, page 529
•
Removing and Replacing Cisco ASR 1000 Series Embedded Service Processors, page 531
•
Removing and Replacing Cisco ASR 1000 Series Router SPAs and SPA Interface Processors, page
533
•
Removing and Replacing the Cisco ASR 1006 Router Power Supplies, page 538
•
Removing and Replacing the Cisco ASR 1004 Router Power Supplies, page 555
•
Removing and Replacing the Cisco ASR 1002 Router Power Supplies, page 565
•
Removing and Replacing the Cisco ASR 1013 Router Power Supplies, page 587
•
Removing and Replacing the Cisco ASR 1001 Router Power Supplies, page 598
•
Repacking the Router, page 612
Cisco ASR 1000 Series Router Hardware Installation Guide
473