Compulite Dlite - Loading Scenes and Chases to Playbacks; Playback Commands for Scenes and Chases

100
Compulite
Chapter 6
Loading scenes and chases to playbacks
You can load up to 20 lighting looks, per snap, to playbacks.
To load playbacks - method 1
1 Press
SCENE or CHASE and select the scene or chase.
Select the scene or chase number. Press the playback’s
SELECT key.
Or
Tap the playback on the touch screen grid.
2 Repeat steps 1 for each scene or chase.
To load playbacks - method 2
Example: Load a scene to playback 11.
1 Press
SCENE and select a scene.
2 Press
PB and 11 on the keypad.
3 Press
ENTER.
4 The scene is loaded to playback 11.
To load a range of playbacks
Example: Load chases 1 through 6 to consecutive playbacks starting from playback 11.
1 Press
CHASE 1  6 to select the range of chasers.
2 Press the
SELECT key for playback 11.
Chase 1 is loaded to playback 11, chase 2 to playback 12, etc.
OR
1 Press
CHASE 1  6 to select the range of chasers.
2 Press
PB and type the playback number on the keypad; for this example, type 11.
3 Press
ENTER.
Chase 1 is loaded to playback 11, chase 2 to playback 12, etc.
Note: Loading playbacks using this procedure overwrites the current contents
on each playback. No warning messages are displayed.
Playback commands for scenes and chases
When a scene or chase loaded on the playback, the SELECT keys function as ON and OFF keys.
Usually, moving the slider off its zero limit turns the playback on. The fade behavior is determined
by the
PB Jump Off Zero setting in the Setup menu. see “Playback behavior” page 105.
To fade in scenes and chases
Press the playback’s ON (SELECT) key.
OR
Move the playback slider off zero.