95
DLITE
Programming Lighting Objects
4 Turn wheel 2 until arriving at 15 (seconds).
5 Press
B to select the beam bank.
6 Turn wheel 2 until
Cut is displayed.
7 Press
ENTER or STORE or tap OK.
Unique fade times for parameters
Each parameter can be assigned a unique fade time that is independent of the scene, cue, or chase
step fade time.
Parameter time is indicated by
T/ on the live display.
To set fade times for specific channels
1 Select the channel(s).
2 Set dimmer levels.
3 To set the fade in time, press
TIME and.
4 To set the delay time, press
TIME again.
Note: When pressing
TIME to access delay time, the fade time that appears in the
command line is automatically saved.
5 Enter the required fade time and press
ENTER.
6 Store the scene, chase step, or cue.
To set parameter fade times for spot parameters
1 Select the spots(s).
2 Set the parameter levels.
3 Select the parameter receiving the unique fade time by pressing its wheel.
4 Press
TIME.
5 Enter the required fade time.
6 Press
ENTER.
Or
Repeat steps 1 through 5 for other fixtures and parameters. When complete, press
ENTER.
7 Store the scene, chase step, or cue.
To set parameter fade times when editing lighting objects
1 Select the lighting object (
SCENE #, QLIST # CUE #, or CHASE # STEP #).
2 Select the fixtures.
3 Set the parameter levels.
4 Select the parameter receiving the unique fade time by pressing its wheel.
5 Press
TIME.
6 Enter the required fade time and press
ENTER.
To Next Page
Loading...