80
Compulite
Chapter 5
To change step order
Example: Exchange step 1 and step 5 in chase 1. Step 1 becomes 5 and step 5 becomes 1.
1 Press
CHASE and select chase 1.
2 Press
SHIFT + STEP.
The touch screen shows the steps in chase 1.
3 Choose step 1.
4 Tap
EXCHANGE.
The chases are displayed on the touch screen
5 Select chase 1.
6 Press
SHIFT + STEP.
The touch screen shows the steps in chase 1.
7 Tap step 5.
8 Press
ENTER or STORE.
Step Stored is displayed. The selected steps have been exchanged.
Chase attributes and run modes
There are two operation modes for running chases:
Automatic - Chases that run automatically are initiated on receiving a go command; the chase
continues running until a stop command is given or until it completes its number of loops.
Manual - Chases that are operated manually require a go command to initiate a fade to each
step.
The number of repeats depends on the number of loops set for the chase.
Chase attributes are:
Number of repeats (loops) - Chases can loop infinitely or the number of loops can be specified.
Direction - Set the chase direction.
Pattern - A prebuilt pattern can be assigned to the chase.
The chase direction and operation modes can be set on-the-fly for chases running on the playbacks
or by editing the chase. When setting these attributes through the chase edit screen, the direction
and operation modes are saved with the chase. When changing the direction or operation mode for
chases running on playbacks, these attributes can be temporary or you can save them to the chase.
Chase patterns
Dlite provides four chase patterns:
Normal - This is the default pattern.
Build - Adds each step to the previous steps.
Random - Runs chase steps in random order.
To Next Page
Loading...