137
DLITE
Effects
To program an effect without selecting a parameter
If you do not select a parameter before pressing
EFFECT, to open the effect editor, the pre-
programmed effects are automatically displayed.
1 Select fixtures.
2 Press
EFFECT.
The
Effect screen is displayed, showing Dlite’s pre-programmed effects.
3 Tap on one of the pre-programmed effects.
The effect begins running on the appropriate parameters.
4 Optional - adjust base, size, offset, rate, swing.
5 Store effect as a scene, chase, step, cue, or effect library.
Releasing effects
You can release all or some of the participating fixtures.
To release effects from the editor
Example: An effect is running, in the editor, on fixtures 1 thorugh 10. Release fixtures 1-3.
1 Select fixtures 1 thorugh 3.
2 Tap
RELEASE.
The effect stops running on fixtures 1 through 3, but continues on fixtures 4 through 10.
To release effects stored in scenes, chase steps, or cues
Example: An effect is running, in scene 1, on fixtures 1 thorugh 10. Release fixtures 1-3.
1 Press
EDIT.
2 Press
SCENE.
The touch screen is now in
Scene mode.
3 Select the scene.
4 Select fixtures 1 through 3.
5 Tap
RELEASE.
The effect stops running on fixtures 1 through 3, but continues on fixtures 4 through 10.
6 Press
UPDATE to store the scene.
To freeze effects
1 Tap
FREEZE EFFECT in the Effect editor.
The effect stops and
Hold appears in the cell of parameters participating in the effect.
2 Tap
FREEZE EFFECT again to run the effect.
Tip! Freeze an effect and then save the lighting state as scene, cue, or chase step.
To Next Page
Loading...