169
DLITE
System Setup and Operations
The keys’ and sliders’ mapped ID appears in the crossfader LED display or in the Page/
Mode LED display. All key LEDs are turned on and blink. Fader or slider amplitude is also
displayed.
To exit diagnostics
Press SETUP again.
Connecting to a PC
You can connect Dlite to a PC and use its hard-drive to backup Dlite data or manage show and
device files. The connection is enabled with Microsoft ActiveSync and a Null Modem Cable.
IMPORTANT! Connect the modem cable before turning on Dlite.
To connect to a PC
1 Connect the Null Modem Cable to the serial connection on Dlite’s back panel.
2 Turn on Dlite.
3 Open ActiveSync and setup the PC port [COM 1 or COM2].
4 On Dlite, press
SETUP.
The setup main screen is displayed.
5 Tap
SYSTEM OPTIONS.
6 Tap
IN/OUT.
7 Tap
CONNECT TO PC.
If the connection is successful,
CONNECT TO PC will toggle to ON.
Check for the file “Mobile Devices” in
My Computer. This file contains all the show and
device data that belongs to Dlite.
ATTENTION! If the modem cable is not connected make sure that CONNECT TO PC is
disabled.
Clearing all data on start up
You may want to occasionally clear Dlite of all data. This is called cold starting the console.
To cold start Dlite
1 Press
CLEAR + ENTER and switch on Dlite.
2 Continue holding
CLEAR + ENTER until the message Loading Application is displayed.
3 Tap
YES to continue the operation or NO to cancel the operation.
To Next Page
Loading...