Compulite Dlite - Programming Links; Renumber Cues

75
DLITE
Programming Lighting Objects
To clear loops
1 Press
QLIST and select the QList.
2 Select the first cue in the loop.
3 Press and hold
SHIFT and then tap CLEAR LOOP.
Programming links
To link cues
Example: Link cues.
1 To link cues: Press
QLIST, select the QList. Press CUE and select the cue.
Note: If the QList is loaded to the crossfader, do not select the QList.
2 Tap
LINK TO.
3 Select the cue.
4 Tap
OK.
To clear links
1 Press
CUE and select the first cue in the link.
Or
Press
STEP and select the first step in the link.
2 Press and hold
SHIFT and then tap CLEAR LINK.
Renumber cues
Use the renumber feature to eliminate point cues or to move a range of cue.
When renumbering cues:
 Loops are deleted
 Links are saved.
 All fade time settings are saved.
To renumber all cues
1 Press
QLIST and select the QList.
More than one QList can be selected.
2 Tap
RENUMBER.
3 Optional: set the start number. If no start number is selected, the cues are renumbered
sequentially starting at 1.
4 Press
ENTER.
Confirmation is requested.
5 Press
ENTER again to confirm the renumber command.