Compulite Dlite - Blind Editor

55
DLITE
Selecting Fixtures and Setting Levels
Blind Editor
 Fixture levels in the blind editor are not output.
 Exiting the blind editor loads any fixture levels, in the blind editor, to the live editor where
they fade to zero.
ATTENTION! Press RESET before exiting the blind editor, to avoid loading the levels to
the live editor.
To activate the blind editor
Press BLIND.
The key’s LED blinks. Blind mode is indicated on the external monitor where
Blind Editor
is displayed in the title bar and there is an orange frame around the display.
To store cues in blind mode
1 Press
BLIND to enter the blind editor.
2 Select fixtures and assign values.
3 Use any store sequence.
To exit blind mode
Press BLIND.
The key’s LED turns off.