173
MIDI
Dlite supports MIDI input/output. You can use MIDI to carry out panel commands. When MIDI is
enabled, Dlite either transmits or receives MIDI commands. When MIDI is disabled, Dlite ignores
all MIDI communication.
To enable MIDI operation
1 Press
SETUP.
2 Tap
SYSTEM OPTIONS.
3 Tap
I/O.
4 Tap
MIDI.
5 Tap
ENABLE.
ENABLE appears on a dark field.
To disable MIDI operation
1 Press
SETUP.
2 Tap
SYSTEM OPTIONS.
3 Tap
I/O.
4 Tap
MIDI.
5 Tap
ENABLE.
ENABLE appears on a light field.
To set the MIDI channel
Use wheel 1 to set the MIDI channel.
To set the MIDI offset
Use wheel 2 to set the MIDI offset.
MIDI commands
Function Description
Snap change
To select and trigger a snap, use MIDI PROGRAM CHANGE
command and a number from 1- 40.
Playbacks control
Use NOTE-ON and a number for On or Off.
NOTE-ON 0-19 – specifies playbacks 1-20.
NOTE-ON # VELOCITY (Data Byte2) = fader%.
Flash
NOTE-ON 20-39
(playbacks 1-20 accordingly) flashes the playback
until turned off.
NOTE-OFF 20-39 turn off flashing.
To Next Page
Loading...