155
DLITE
Advanced Programming
All parameters in all spots that are output from playbacks are selected.
OR
1 Press
CHAN and select channels.
2 Press
SHIFT + tap ACTIVE ALL.
All channels that are output from playbacks are selected.
OR
1 Press
EXTRA and select extras.
2 Press
SHIFT + tap ACTIVE ALL.
All extras that are output from playbacks are selected.
To grab all output from the playbacks
Press SHIFT + ACTIVE CALL in idle.
Grabs all fixtures and parameters with levels that are output from playbacks or the cross-
fader.
Tip! Use ACTIVE to select fixtures for groups.
To set parameter levels after using Active
Use the wheels to set parameter levels for all selected fixtures.
The parameter levels are set relatively to the original levels. Example: Active grabbed
channel 1, output from the crossfader, and 2, output from playback 12. Channel 1 is @
50%, channel 2 is @ 75%. Adding 25% using the dimmer wheel, brings channel 1 to 75%
and channel 2 to 100%.
Use the @ to set an absolute level for the dimmer in all selected fixtures or select a parameter
and use
@ to set an absolute level for the selected parameter.
Select parameters for editing and then store as a lighting object or library.
Press ENTER after pressing ACTIVE.
All parameter levels for the selected fixtures are active in the editor. You can now select
specific parameters for editing or store the editor as a lighting object or library.
Using store options
STORE OPTIONS provides added control over what is stored or updated in scenes, cues, and chase
steps. Store options are available on the touch screen in store or update mode or in the
Setup menu.
The default behavior is configured in the
Setup menu or a store option can be selected on-the-fly
using the touch screen buttons. Default settings are saved in the show file.
Figure 34: Store options
To Next Page
Loading...