135
DLITE
Effects
To set an offset
1 Select the fixtures and the parameter.
2 Press
EFFECT to open the Effect screen.
3 Tap
PAGE WHEELS to see the next page of wheels.
4 Use the wheel to set the offset.
Examples of Offset uses
Example: Program an effect where the dimmers channels 1 through 4 are sequentially on or off in a
jump effect.
Setting an effect to run in a wave or one-on offset
The
WAVE/ONE-ON button is a quick way to set a simple offset.
Wave - The effect is fanned evenly over the parameters for selected fixtures.
One-On - The effect is spread over the parameters in the range of selected fixtures, so that one
fixture is moving while the others are waiting.
All - The effect runs simultaneously on the selected parameters for all the participating
fixtures.
To use wave or one-on in an effect
Example: Offset a jump effect running on the dimmers for moving lights 1 through 6.
1 Select moving lights 1 through 6.
2 Set dimmer levels.
3 Press
EFFECT.
The touch screen is now in effect mode.
4 Tap
JUMP.
The effect begins running.
5 Tap
WAVE/ONE-ON.
The effect is now running with the wave offset.
Wave appears next to the fixture number on
the touch screen.
6 Tap
WAVE/ONE-ON again to use the One-On offset.
The effect is now running with the one-on offset.
One appears next to the fixture number
on the touch screen.
Channel Offset
10
225
350
475
To Next Page
Loading...