34
Compulite
Chapter 2
5 Press RESET to exit the DMX port display.
To overwrite an existing patch
1 Press
DIMMER and select the range of DMX addresses.
2 Press
CHANNEL and select the channel range.
3 Tap Set.
An overwrite warning is displayed.
4 Tap
OK to confirm the command.
Using park
Fixture parameter levels, dimmer levels, and scenes can be parked at specific levels. Parked items
constantly output at their parked level and do not respond to level changes in the editor or to the
general master.
The proportional patch affects the output of parked dimmers. Example: If a dimmer has a propor-
tional patch of 50% and the dimmer or its patched fixture is parked at 70%, the output is 35%. This
is valid only when the proportional patch has been set before parking the dimmer or fixture.
Note: The general black out key (
B.O.) overrides parked items.
Pressing
PARK, displays the park options on the touch screen.
To park fixture parameters
1 Press
PARK.
2 Select fixtures and parameters.
3 Set the parked level.
4 Press
PARK.
Or
Press
ENTER.
5 Tap
OK.
To park dimmers
1 Press
PARK.
2 Press
DIM and select dimmers.
3 Set the parked level.
Park Options What it does
PARK
Park selected items at the specified levels.
UNPARK
Free the selected items from their parked state.
UNPARK ALL
Free the all parked items from their parked state.
To Next Page
Loading...