Compulite Dlite - Using Rem DIM

160
Compulite
Chapter 11
To apply highlight
1 Select a fixture, or a range of fixtures, or a group.
2 Press
HIGHLIGHT.
3 Press
NEXT or PREVIOUS to move to the next or previous fixture.
To exit highlight
Tap HIGHLIGHT or press RESET. HIGHLIGHT now appears on a light field.
To edit pan and tilt using highlight
Example 1: The current cue uses position library 1. In the current venue the bar is a bit higher
than usual and the position library requires editing.
1 Select fixtures.
2 Apply the library.
3 Tap
HIGHLIGHT.
4 Edit pan and tilt.
5 Update the library.
Example 2: Edit specific fixtures in library 1.
1 Select fixtures.
2 Apply the library.
3 Tap
HIGHLIGHT.
4 Press
NEXT until identifying the fixture that requires editing.
5 Edit pan and tilt.
6 Repeat steps 5 and 6 until all the fixtures are in place.
7 Update the library.
To apply lowlight
1 Select a fixture or a range of fixtures.
2 Press
SHIFT + HIGHLIGHT.
3 Press
NEXT or PREV to move to the next or previous fixture.
Using Rem Dim
The Rem(ainder) Dim feature that forces all active dimmers, excluding the selected fixtures, to zero
allows you to isolate a problem fixture or turn off most of the fixtures when programming new
lighting objects.
REM DIM behavior:
 If the dimmer of the selected fixture is higher than zero, it remains at that level and all other
fixtures fade to zero.