161
DLITE
Advanced Programming
If the dimmer of the selected fixture is at zero, it goes to the ON value and all other fixtures
fade to zero.
Since this is an editor function all parameters and wheels are available for fixture editing while
REM DIM is active. You can also apply a library to the REM DIM selection.
New scenes, cues, and chase steps can be stored while the REM DIM feature is active. Be aware
that zr intensity values, under
REM DIM control, will also be stored in the new or updated
lighting object.
Exiting Rem Dim releases all unchanged values to playback device control. Parameter and
dimmer levels in the editor are retained.
To blackout all fixtures except the selected fixtures
1 Select the fixture(s).
2 On the touch screen, tap
REM DIM.
The dimmers of the selected fixtures are entered into the editor at their stored level. All
other fixtures are entered into the editor and forced to zr.
3 Tap
REM DIM to restore previous levels and release the editor.
4 To select and isolate another fixture, repeat steps 1 and 2.
To locate a fixture
1 Select a fixture to start from.
2 On the touch screen, tap
REM DIM.
3 Only the selected fixture’s dimmer remains on. All other fixtures are entered to the editor
and forced to zr.
4 Press
NEXT or PREV to advance.
The active fixture fades to its stored level and the previous fixture is forced to zero.
5 To skip a large number of fixtures without exiting, just select a fixture and tap
REM DIM
again.
To store a cue using REM DIM
Example: Cue 10 has back light, a cyclorama color wash, and a special comprised of three
fixtures. You want to quickly isolate the three-fixture special and store only the special as in
cue 11.
1 Select the three fixtures.
2 Set an intensity level.
3 Tap
REM DIM.
The back light and color wash are forced to zero.
4 Store a new cue.
5 All zero intensity values are stored in the new cue.
To Next Page
Loading...