46
Compulite
Chapter 3
The display format for step parameters depends on the step’s definition in the device builder
application. Some examples of step displays are: 2.FL (step at its maximum value) or text,
such as,
Fast Strobe. see “Device Builder” page 167.
FULL, ON, and ZR can also be used to set parameter levels.
To set parameter levels
Example: Set levels for color and beam parameters.
1 Select the spots.
2 Set the dimmer intensity.
3 Press
C to switch wheels to the color bank.
4 Set levels using the wheels.
Or
Select a parameter press
@ and choose a level using the keypad.
Note: If the parameter you are looking for is not visible, press
C again to page
to the next 3 parameters in the bank.
5 Press
B to switch wheels to the beam bank.
6 Set levels using the wheels.
Or
Select a parameter press
@ and choose a level using the keypad.
To set levels for step parameters
Example: Jump from color to color on the color wheel (CW).
1 Select the spots.
2 Set the dimmer intensity.
3 Press
C to switch wheels to the color bank.
Note: If the parameter you are looking for is not visible, press
C again to page
to the next 3 parameters in the bank.
4 Press the (CW) wheel.
5 Tap
STEP UP OR STEP DN.
The color wheel jumps from color to color.
Using the faders to set parameter levels
You can also use the faders in context mode to set parameter levels. Example: You have selected 4
spots of the same device type. This device uses 5 DMX channels. When
PARAM CONTROL is
enabled, faders 1 through 5 control parameters for spot, faders 6 through 7 control parameters for
spot 2, etc.
To Next Page
Loading...