Compulite Dlite - In;Out Crossfader Masters; Fade Controls; Playing Back Qlists on the Crossfader

109
DLITE
Playbacks and the Crossfader
In/Out crossfader masters
The masters can be at the bottom end stop, the top end stop, or split.
Fade controls
The crossfade has three dedicated playback controls.
Playing Back QLists on the crossfader
To load QLists
1 Press QLIST.
2 Select the QList on the keypad or the touch screen.
3 Press
SELECT above the crossfader.
The QList is loaded to the crossfader.
4 Press
GO, to fade the first cue.
To preload the crossfader out of sequence
Example: Cue 5 is the active cue. Cue 6 is the incoming cue. From cue 5 fade to cue 10.
1 Select cue 10.
2 Press
SELECT above the crossfader.
10 is displayed as the incoming cue.
3 The next go command initiates a fade to cue 10.
In/Out master position Active cue/output
In master at bottom end stop
Out master at bottom end stop
Lower display - cue on stage
Upper display - next cue in the sequence
In master at top end stop
Out master at top end stop
Upper display - cue on stage
Lower display - next cue in the sequence
In master at top end stop
Out master at bottom end stop
There is no active cue
In master at bottom end stop
Out master at top end stop
Both the current cue (shown in the lower display)
and the next cue (shown in the upper display) are
active
Control What it does
GO
Pressing GO initiates a fade to the next cue in the sequence. The fade takes place
in cue time.
HOLD
Pressing HOLD stops an ongoing fade.
BACK
Pressing BACK initiates a fade to the previous cue. the fade takes place in system
time.