Danfoss VLT AutomationDrive FC 360 Programming Guide

Programming Guide | VLT® AutomationDrive FC 360
Option Name Description
[17] Above frequency, high The output speed is higher than the
setting in parameter 4-41 Warning Freq.
High.
[18] Out of feedb. range The feedback is outside the range set in
parameter 4-56 Warning Feedback Low
and parameter 4-57 Warning Feedback
High.
[19] Below feedback, low The feedback is below the limit set in
parameter 4-56 Warning Feedback Low.
[20] Above feedback, high The feedback is above the limit set in
parameter 4-57 Warning Feedback High.
[21] Thermal warning The thermal warning turns on when the
temperature exceeds the limit in the
motor, the drive, the brake resistor, or the
thermistor.
[22] Ready, no thermal warning The drive is ready for operation, and there
is no overtemperature warning.
[23] Remote, ready, no TW The drive is ready for operation
and is in auto-on mode. There is no
overtemperature warning.
[24] Ready, no over-/under voltage The drive is ready for operation and the
mains voltage is within the specified
voltage range (see the Specifications
section in the design guide).
[25] Reverse The motor runs (or is ready to
run) clockwise when logic = 0 and
counterclockwise when logic = 1. The
output changes as soon as the reversing
signal is applied.
[26] Bus OK Active communication (no timeout) via
the serial communication port.
[27] Torque limit & stop Use in performing a coast stop and in
torque limit condition. If the drive has
received a stop signal and is at the torque
limit, the signal is logic 0.
[28] Brake, no brake warning The brake is active and there are no
warnings.
[29] Brake ready, no fault The brake is ready for operation and there
are no faults.
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 151

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English