Danfoss VLT AutomationDrive FC 360

To Next Page

To Previous Page

9-63 Actual Baud Rate

Default value: [255] No baudrate found Parameter type: Option

Setup: All setups Conversion index: –

Data type: Uint8 Change during operation: True

Show the actual PROFIBUS baud rate. The PROFIBUS master automatically sets the baud rate.

Option Name

[0] 9,6 kbit/s

[1] 19,2 kbit/s

[2] 93,75 kbit/s

[3] 187,5 kbit/s

[4] 500 kbit/s

[6] 1500 kbit/s

[7] 3000 kbit/s

[8] 6000 kbit/s

[9] 12000 kbit/s

[10] 31,25 kbit/s

[11] 45,45 kbit/s

[255] No baudrate found

9-64 Device Identification

Default value: 0 Parameter type: Range (0–0), Array [10]

Setup: All setups Conversion index: 0

Data type: Uint16 Change during operation: True

The device identification parameter. The data type is array [n] of unsigned16. The assignment of the 1st sub-indexes is defined and

shown in the following table.

This parameter is only visible via PROFINET.

Table 19: Device Identification 1st Sub-index Assignment

Index Content Value

0 Manufacturer 128

1 Device type 1

2 Version xxyy

3 Firmware date year yyyy

4 Firmware date month ddmm

Programming Guide | VLT® AutomationDrive FC 360

Other manuals for Danfoss VLT AutomationDrive FC 360