Danfoss VLT AutomationDrive FC 360

Table 12: Active Parameters (continued)
Parameter 1-10 Motor Construction [0] Asynchron [1] PM, non salient SPM [3] PM, salient IPM
Parameter 1-73 Flying Start x x x
Parameter 1-80 Function at Stop x x x
Parameter 1-88 AC Brake Gain x
Parameter 1-90 Motor Thermal Protection x x x
Parameter 2-00 DC Hold Current x x x
Parameter 2-01 DC Brake Current x x x
Parameter 2-02 DC Braking Time x x x
Parameter 2-04 DC Brake Cut In Speed [Hz] x x x
Parameter 2-06 Parking Current x x
Parameter 2-07 Parking Time x x
Parameter 2-10 Brake Function x x x
Parameter 2-16 AC brake Max. Current x
Parameter 2-17 Over-voltage Control x x x
Parameter 4-10 Motor Speed Direction x x x
Parameter 4-14 Motor Speed High Limit [Hz] x x x
Parameter 4-16 Torque Limit Motor Mode x
Parameter 4-17 Torque Limit Generator Mode x
Parameter 4-18 Current Limit x x x
Parameter 4-19 Max Output Frequency x x x
Parameter 4-43 Motor Speed Monitor Function x x x
Parameter 4-44 Motor Speed Monitor Max x x x
Parameter 4-45 Motor Speed Monitor Timeout x x x
Parameter 4-58 Missing Motor Phase Function x x x
Parameter 4-59 Motor Check At Start x x x
Parameter 7-01 Speed PID Droop x x x
Parameter 7-02 Speed PID Proportional Gain x x x
Parameter 7-03 Speed PID Integral Time x x x
Parameter 7-04 Speed PID Differentiation Time x x x
Parameter 7-05 Speed PID Diff. Gain Limit x x x
Parameter 7-06 Speed PID Lowpass Filter Time x x x
Parameter 7-07 Speed PID Feedback Gear Ratio x x x
Parameter 7-08 Speed PID Feed Forward Factor x x
54 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360