Develop ineo 350 - Page 186

Field Service Ver. 1.0 Aug. 2005 10. Adjustment item list
147
bizhub 200/250/350Adjustment / Setting
• This table shows the adjustment items that are required when a part of the machine has
been replaced. Priority order, if applicable, during the adjustment procedures is indicated
by the corresponding number in the parentheses.
N0
Replace ATDC Sensor Replace Mechanical Control Board Replace PH Unit Replace CCD Unit Wind Scanner Drive Cables Install Scanner Unit Replace Multi Bypass Unit Install Hard Disk Install Optional Original Size Sensors
1(1)
2(2)
3(8)(2)
4(9)(3)
5(6)(1)
6(7)(2)
7(2)
8(5)
9 {
10
11 (2)
12 (1)
13 (2)
14
15
16
17
18
19
20
21 (3)
22 (4)
23 (5)
24 (1)
25
(1)
26 (1) {
27 (1)
28 (4)
29 (3)
30 (2)