15. Initial Mode Field Service Ver. 1.0 Aug. 2005
208
bizhub 200/250/350
Adjustment / Setting
15. Initial Mode
15.1 Initial Mode Function Setting Procedure
1. Remove the Compact Flash Cover [1].
2. Press the Warm Restart switch [2].
3. When “z” appears at the center on the left-hand side of the screen, enter “3” from the
10-Key Pad.
4. Enter the 8-digit service code and touch [END]. (Default value: 00000000)
NOTE
• When [END] is touched after a wrong service code has been entered, the Basic
screen reappears.
• At the fourth access after entries of three wrong access codes, [END] is not avail-
able on the screen. It is therefore necessary to turn OFF and ON the Main Power
Switch.
• If you forget the service code, it becomes necessary to replace the RAMS Board
with a new one. Take necessary steps not to forget the service code.
• The RAMS Board is not available as a replacement part. If it requires replacement,
contact Office Printing Support Division by way of CSES.
5. Select a function.
15.1.1 Exiting
• Touch [Exit].
4040F3C533DA
[1]
[2]
4040F3C521DA
To Next Page
Loading...
